lap joint

英 [læp dʒɔɪnt]

美 [læp dʒɔɪnt]

（互）搭接（头）；叠接；搭接接头；搭接缝; 搭接接头；搭接焊缝

计算机化学

英英释义

noun

• joint made by overlapping two ends and joining them together
  Synonym:splice

双语例句

• This paper is to discuss the interlaminar stresses of adhesive lap joint by the energy method without considering the adhesive layer.
  本文以能量法求解无胶层厚度的搭接接头的层间应力。
• Numerical analysis on stress distribution in adhesive-welded double lap joint of aluminum
  铝胶焊双搭接接头上应力分布的数值分析
• The BEM technique for adhesive-bonded structure proves valid by comparing the stress distribution for double lap joint calculated in this paper with that calculated by finite element method.
  对双搭接接头进行了边界元应力分析，并和有限元结果进行了对比，从而证实本文方法的有效性。
• The structure of intersecting Lap joint Between steel pipe has been widely applied in engineering project, such as Oil and gas pipelines, Pressure vessel and Various forms of pipe truss structure.
  工程中钢管与钢管的相贯搭接广泛的应用于油气管道、压力容器以及各种形式的管桁架钢结构中。
• The elasto-plastic finite element method ( FEM) was used to investigate the effect of the elastic modulus of adhesive on the stress and strain distribution in adhesively bonded aluminium single lap joint.
  利用弹塑性有限元法研究胶粘剂的弹性模量对单搭接接头应力应变分布的影响。
• The shear strength and elongation of the lap joint increase with the increase of strain rate.
  焊点的剪切强度及伸长量随应变速率的增加而增加。
• The research is carried out with the method of orthogonal test to study the effects of some main parameters such as Poisson ratio, elastic modulus and adherend of thick on the peck value of the Von Mises equivalent stress distributed in adhesively bonded aluminium single lap joint.
  运用正交试验法研究了几个主要力学和几何参数如泊松比，弹性模量和被粘物厚对单搭接接头VONMISES等效应力的影响。
• The lap joint produces bending effect under the action of tensile load and the bending degree decreases with the increase of yield limit of base material.
  搭接接头在拉伸载荷作用下会产生折弯效应，折弯程度随被钎焊母材屈服极限的增加而减小。
• Taking the form of lap joint as an example, the effect of final assembling deviation affect by the assembly sequence was analyzed by adopting the method of worse condition.
  以搭接接头形式为例，采用最坏情况法分析了装配顺序对最终装配偏差的影响。
• Numerical analysis on stress distribution in single lap joint with a metal inlay
  含镶嵌块单搭接接头应力分布的数值分析